Voron 3Dprinter, update 6

• Posted on 7 May 2020
• By Team MakerBeam
• Posted in Voron
• 0

We are busy cutting and tapping 200mm MakerBeamXL black anodised. We are doing a better job of keeping our beams within the norm. The newly cut beams are cut to ISO 2768-m.

We are cutting, tapping, cleaning and measuring a lot these days. The measurements we took we can show in a graph. We had over 400 datapoints. That is over 400 beams cut and tapped. The few beams on the very left of the spectrum were thrown out.